349
Appendix
Mod./P.Shift
Other modulation and pitch shift effects
032: Tremolo
This effect modulates the volume level of the input signal. The
effect is stereo, and offsetting the LFO of the left and right phases
from each other produces a tremolo effect between left and
right.
a:LFO Waveform
This parameter selects the LFO waveform. Vintage wave simu-
lates the characteristics of the tremolo created on a guitar ampli-
fier. Combining this effect with the Amp Simulation will make a
realistic, vintage tremolo amplifier sound.
b: LFO Phase [degree]
This parameter determines the difference between the left and
right LFO phases. A higher value will simulate the auto-pan effect
in which the sound is panned between left and right.
033: Envelope Tremolo
This effect uses the input signal level to modulate a stereo trem-
olo. You can simulate a tremolo effect that becomes deeper as it
fades out while the level gets lower.
a
LFO Waveform Triangle, Sine, Vintage, Up, Down
Selects LFO Waveform
☞
LFO Shape –100...+100
Determines how much the LFO waveform is changed
☞ Fx:020
b
LFO Phase [degree] –180...+180
Sets the LFO phase difference between the left and right
☞
c
LFO Frequency [Hz] 0.02...20.00Hz
Sets the LFO speed
☞ Fx:009,
Src
Selects the modulation source of LFO speed
Off...Tempo
Amt –20.00...+20.00Hz
Sets the modulation amount of LFO speed
d
BPM/MIDI Sync Off, On
Switches between using the frequency of the LFO speed and using the
tempo and notes
☞ Fx:009,
BPM
Selects MIDI Clock and assigns tempo
MIDI, 40...240
☞ Fx:009
Base Note
Selects the type of notes that specify the LFO speed ☞ Fx:009
Times x1...x16
Sets the number of notes that specify the LFO speed
☞ Fx:009
e
Depth
Sets the depth of LFO modulation
0...100
Src Off...Tempo
Selects the modulation source of the depth of modulation
Amt –100...+100
Sets the modulation amount of the depth of modulation
f
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 330
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 330
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 330
–100...+100
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
LFO Phase
LFO: Tri/Sin/Vintage/Up/Down
LFO Shape
Tremolo
Tremolo
a
Envelope Sens (Envelope Sensitivity)
Sets the envelope sensitivity of the input signal
0...100
Envelope Shape
Sets the envelope curve shape of the input signal
–100...+100
b
LFO Waveform Triangle, Sine, Vintage
Selects LFO Waveform
LFO Shape –100...+100
Determines how much the LFO waveform is changed
☞ Fx:020
c
LFO Phase [degree] –180...+180
Sets the LFO phase difference between the left and right
☞ Fx:032
d
LFO Frequency [Hz]
Sets the LFO speed
0.02...20.00Hz
☞
Envelope Amount [Hz] –20.00...+20.00Hz
Sets the changes of the LFO speed according to the input signal level
☞
e
Depth
Sets the depth of LFO modulation
0...100
☞
Envelope Amount –100...+100
Sets the changes of the modulation depth according to the input signal level
☞
f
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 330
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 330
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 330
–100...+100
Tremolo - LFO Waveform
Triangle
Sine
Vintage
Up
Down
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
LFO Phase
LFO Shape
Envelope Sens
+
Envelope
LFO: Tri/Sin/Vintage
Envelope Shape
Tremolo
Tremolo
To Next Page
Loading...
Need help?
General
