85
Style Play operating mode
Mixer/Tuning: FX Send
Reference
C0 Center.
R+1…R+63 Right stereo channel.
Off If the track’s output status is Left&Right (normal
setting), the direct (uneffected) signal is not sent
to the outputs; only the FX signal is heard for this
track.
If the track is sent to a separate output, no FX is
sent to any output.
To program the output status for each track, see
“Audio Output: Sty/Kbd” on page 239.
Volume
Track’s volume.
0…127 MIDI value of the track’s volume.
Play/Mute icon
Track’s play/mute status.
Play status. The track can be heard.
Mute status. The track cannot be heard.
Mixer/Tuning: FX Send
This page lets you set the level of the track’s direct (uneffected)
signal going to the Internal FX processors. The effect processors
included in Pa1X are connected in parallel, so you can decide
which percentage of the direct signal can be effected:
In case you do not want to send a track’s direct signal to the out-
put, but only the effected signal (as when using “insert” effects,
like Rotary, Distortion, EQ…), just set the Pan to Off (see “Pan”
above):
There are four Internal FX processors in Style Play mode (two
for Keyboard and Pad tracks, two for Style tracks). You can
assign them any kind of available effects, but we found it conve-
nient to arrange them in the following way, for most of the
Styles, STS and Performances included with the Pa1X:
FX A Reverb processor for the Style tracks.
FX B Modulating FX processor for the Style tracks.
FX C Reverb processor for the Realtime (Keyboard)
tracks.
FX D Modulating FX processor for the Realtime (Key-
board) tracks.
Use the TRK. SEL. button to switch from Keyboard to Style
tracks, and vice-versa.
Send level (A…D)
0…127 Level of the track (direct) signal sent to the effect
processor.
Play/Mute icon
Track’s play/mute status.
Play status. The track can be heard.
Mute status. The track cannot be heard.
Sty
Sty
Track Out L/R
FX Processor
Track Out L/R
FX Processor
Sty
Sty
To Next Page
Loading...
Need help?
General
