243
Global edit mode
Voice Processor Setup: Lead Voice
Reference
Voice Processor Setup: Lead Voice
This page lets you adjust parameters for the Lead voice (i.e., the
singer’s voice).
Mic Input
Low Cut
Low cut filter. 12dB per octave. Cutoff frequency options include
60, 80 and 120 Hz.
Delay Compensation
Turning this on delays the lead vocal so that the humanized har-
mony voices will be randomly ahead and behind the lead voice.
Turning this off results in minimum lead voice processing delay.
Pan/Volume
Pan knob
Adjusts panning for the lead voice. L64 (panned fully left) to R63
(panned fully right).
Level knob
This parameter sets the Lead Voice level.
DryOff This setting mutes the dry input vocal, but allows
the thickening voices to pass through the unit as
if the lead level was set to 0dB.
Off Lead Voice is turned off.
-30dB … 0dB Lead Voice level.
Voice Processor Setup: Dynamics / EQ
In this page you can adjust parameters for the Compressor/Gate
and Equalizer, applied to the Lead and Harmony voices.
Assign
Dyn
Compressor/Gate assignment. The options are Off, Lead + Har-
mony, Harmony or Lead. The compressor has auto-makeup
gain, so there are no output levels problems when selecting a dif-
ferent option.
EQ
EQ assignment. The options are: Off, Lead + Harmony, Har-
mony or Lead.
Dynamics
The Voice Processor has dynamics processing optimized for
vocals.
Thresh knob
Compressor Threshold. Range: 0 to -60 dB.
Ratio knob
Compression ratio. Range: 1.1:1 to 64:1.
Gate knob
Gate Threshold. Range: Off, -70dB to 0dB
EQ
The Voice Processor has an extremely flexible 3-band EQ with
frequency and gain-adjustable high and low shelving bands, as
well as a fully parametric band with Q control.
Low Gain knob
Low Shelving Frequency cut/boost. Range: ±12 dB.
Low Frequency knob
Low Shelving Frequency center frequency. Range:
80Hz…16kHz.
VPs
VPs
VPs
VPs
VPs
VPs
VPs
VPs
VPs
VPs
VPs
To Next Page
Loading...
Need help?
General
