397
Installing the Korg CDRW-1 Drive
Appendix
Please note: Follow these instructions if your Pa1X (a) does not
include a small screw under the CD-RW slot (shown in the diagram),
and (b) does not include a mounting tray inside the slot itself.
If the above is not true, please follow the instructions you can down-
load from our website (www
.korgpa.com).
A Korg CDRW-1 CD player/writer can be installed into your Pa1X. Installation will require a “+” (cross-point) screwdriver. Please con-
tact your Korg dealer for more information on how to obtain this option.
Warning: Installation of the CD drive is done at the user’s own risk. Korg will assume no responsibility for any damage or injury resulting
from improper installation or use.
Installing the Korg CDRW-1 Drive
Pa1X Pro Pa1X
1) Before you begin, turn the instrument off, and disconnect the power cable.
2) Push the small unlock button with the tip of a pen, to open the CD drive’s (A) cover, and remove the paper protection.
3) With the help of a cross-point screwdriver, remove the two screws
(a) securing the floppy disk drive cover (B), and remove the cover itself.
3) With the help of a cross-point screwdriver, remove the two screws
(a) securing the CD slot cover (B), and remove the cover itself.
a
a
push
A
A
push
A
A
a
a
B
a
a
B
To Next Page
Loading...
Need help?
General
