210
Sound operating mode
LFO: LFO2
LFO: LFO2
Here you can make settings for the LFO2, which is the second
LFO that can be applied to the selected oscillator. See “LFO:
LFO1” for more information on the parameters value.
However in “Frequency Modulation”, the LFO cannot be
selected as a modulation source in “AMS1” or “AMS2.”
Effects: FX Select
Here you can select two effects for the whole Sound, switch them
on/off, and specify chaining.
Note: For details on the effects, refer to the “Effects” chapter.
FX 1/2 Group
Send
Send level for each effect.
Drum samples have their own send level settings (see “Send
FX1” and “Send FX2” on page 197). Use this parameter to
adjust the general offset of the Drum Kit.
000…127 Effect level.
FX1/2
Use these parameters to select the effect type for effect 1/2. See
the “Effects” chapter for more information.
Note: If 000: No Effect is selected, the output from the master effect
will be muted.
Wet/Dry
Mix between the effected (Wet) and direct (uneffected, Dry) sig-
nal.
Dry Direct signal only.
Wet Effected signal only.
nn:nn Percentage of Wet/Dry signal.
2>1
Use this parameter to send the output of effect 2 to the input of
effect 1.
000…127 Level of the signal exiting the effect 2 going back
to the effect 1.
Send to Master
This parameters allows you to decide if the direct + effected sig-
nal must go to the Master, or just the effected signal.
On Only the effected signal will be sent to the Audio
Outputs. The direct (non-effected) signal will not
be sent.
Off Both the effected signal and direct signals will be
sent to the Audio Outputs.
Effects: FX1
In this page you can edit the effected assigned to the FX1 (A or
C) effect processor (usually reverb). See the “Effects” chapter for
more information.
Effects: FX2
In this page you can edit the effected assigned to the FX2 (B or
D) effect processor (usually modulating effect). See the “Effects”
chapter for more information.
To Next Page
Loading...
Need help?
General
