180
Sequencer operating mode
Mixer/Tuning: Tuning
Play/Mute icon
Track’s play/mute status.
Play status. The track can be heard.
Mute status. The track cannot be heard.
Mixer/Tuning: Tuning
Parameters
See “Mixer/Tuning: Tuning” on page 86.
Mixer/Tuning: Sub Scale
This page lets you program an alternative scale for the selected
tracks (via the “Track Assign” parameter).
The remaining
tracks (if any) use the basic scale set in Global mode (see
“Main Scale” on page 231).
Note: Quarter Tone selection and activation of the Sub-Scale on
each track of a Song, can be received by MIDI (i.e., by an external
sequencer or controller). Conversely, selection of Quarter Tone set-
tings, or activation of the Sub-Scale on each track of the Song, can
be sent by the Pa1X to an external MIDI recorder as System Exclu-
sive data.
Parameters
See “Mixer/Tuning: Sub Scale” on page 86.
Track Assign
Check the parameter corresponding to each track where the
Sub-Scale must be used.
Effects: FX Select
This page allows you to select effects to be assigned to the four
Internal FX processors (A-D).
Note: When you stop the Song, or select a different Song, the
default effects are selected again. You can, however, stop the Song,
change the effects, then start the Song again. Save the Song to per-
manently change the effects.
FX A…D
Effects assigned to the corresponding effect processors. Usually,
A and C are reverbs, while B and D are modulating effects (cho-
rus, flanger, delay…). For a list of the available effects, see
“Effects” on page 329.
Wet/Dry
Mix between the effected (Wet) and direct (uneffected, Dry) sig-
nal.
Dry Direct signal only.
Wet Effected signal only.
nn:nn Percentage of Wet/Dry signal.
B to A, D to C
Amount of the B effect going back to the input of the A effect, or
of the D effect going back to the input of the C effect.
Mod.Track (Modulating Track)
Source track for modulating MIDI messages. You can modulate
an effect parameter with a MIDI message generated by a physical
controller.
To Next Page
Loading...
Need help?
General
