FlexLine plus, Programs
113
7.13.7 Check Slope
Description The subprogram Check Slope is used for as-built checks and to get information about
slopes, for example on a natural surface. If the parameter offset left/right and height
difference are not entered, the point on the horizontal alignment is the hinge point.
Defined chainage and increment values will not be considered in the subprogram Check.
Access Press Ch Slp from the Define Stake/Check/Slope values screen.
Slope Check Hinge
Val.
Next step •Either, press Meas to measure and record.
• Or, press ESC to return to the Define Stake/Check/Slope values screen.
• Or, continue selecting ESC to exit the application.
P1 Measured point
a Horizontal alignment
b Defined offset
c Defined height difference
d Hinge point
eActual slope
f Natural surface
g Offset to hinge point
h Offset to alignment
i Height difference to hinge point
j Height difference to alignment
TSOX_055
e
f
a
c
b
h
i
j
g
d
P1
Field Description
Offset Defined horizontal offset. Left, Right or Center.
Chainage Current chainage from measured point.
Offs.Hng Offset to hinge. Measured offset to the horizontal alignment including
offset right and offset left.
∆H Hinge Height difference to the hinge point. The vertical offset between the
defined height at the current chainage, and the measured position
including defined height difference.
Act. Slp The measured slope ratio of the measured point to the hinge point.
Hinge Slope distance from the measured point to the hinge point.
Height Height value of the measured point.
Offs.Aln Measured offset to the horizontal alignment excluding offset right and
offset left.
∆H Aln Height difference to the alignment. The vertical offset between defined
height at the current chainage, and the measured position, excluding
the defined height difference.
Aln Slope distance from the measured point to the alignment.
To Next Page
Loading...
