Leica FlexLine plus - EDM Tracking; Backsight Check

FlexLine plus, Favourites
128
8.5 EDM Tracking
Access
Description This favourite activates or deactivates the tracking measurement mode. The new
setting is displayed for about one second and then set. This favourite can only be acti-
vated from within the same EDM mode and prism type. The following options are avail-
able.

The last active measurement mode remains set when the instrument is switched off.
8.6 Backsight Check
Description This favourite enables the user to remeasure to the point(s) used for Station Setup.
This is useful to check if the station position is still correct after measuring some
points.
Access
Backsight Check This screen is exactly the same as the Stakeout screen, except that the available PtIDs
are restricted to the points used for the last orientation. Refer to "7.4 Stakeout" for
information about the screen.

When setting up a station by local resection, check the coordinate system of the
points used from the list.
1. Press the FNC/Favourites key when within any program.
2.
Select EDM Track from the Favourites Menu.
EDM Mode Tracking mode OFF! <=> Tracking mode ON!
Prism Precise+ <=> Tracking / Precise&Fast <=> Tracking
Non-Prism NP-Precise <=> NP-Tracking
1. Press the FNC/Favourites key when within any program.
2. Select BS-Check from the Favourites Menu.