Leica FlexLine plus - 12.6 Loading Software and Languages

FlexLine plus, Tools
145
12.6 Loading Software
Description To load program software or an additional language, connect the instrument to Instru-
ment Tools via the serial interface and load using "Instrument Tools - Software
Upload". Refer to the Instrument Tools online help for further information.
For instruments fitted with a Communication side cover, the software can be loaded
via a USB memory stick. This process is described below.
Access

• Never disconnect the power supply during the system upload process. The battery
must be at least 75% capacity before commencing the upload.
Loading firmware
and languages
step-by-step
1.
Select Tools from the Main Menu.
2. Select Load FW from the Tools Menu.

All firmware and language files must be stored in the system folder to be trans-
ferred to the instrument.
1. To load firmware and languages: Select F1 Firmware,EDM-FW,Logo. The Select
File! screen will appear.
To load only languages: Select F2 Language(s) only and skip to step 4..
2. Select the firmware file from the system folder of the USB memory stick.
3. Press Cont.
4. The Upload Languages! screen will appear displaying all language files in the
system folder of the USB memory stick. Select Yes or No for a language file to
be uploaded. At least one language must be set to Yes.
5. Press Cont.
6. Once successfully loaded, the system will shut down and restart again automat-
ically.