Leica FlexLine plus - Tunnel

FlexLine plus, Programs
121

• Depending on the number of measured points the calculation may take some time.
A message is displayed during the processing.
• Adjusted points are stored as fixpoints with an additional prefix, for example point
BS-154.B is stored as CBS-154.B.
• After the adjustment the Traverse program is exited and the system returns to the
Main Menu.
Messages The following are important messages or warnings that may appear.
7.15 Tunnel

Refer to the separate manual "Leica FlexLine plus Tunnel Application".
Scale PPM value defined by the calculated distance between start and end
point divided by the distance measured.
Use Scale Whether to use the calculated ppm.
Field Description
Messages Description
Memory is nearly full! Do you
want to continue ?
This message occurs if less than 10% of the memory
is free. It is not recommended to start a traverse if
the memory is almost full. Doing so, may mean that
the traverse measurements and the results cannot
be saved.
Current job contains an
adjusted Traverse. Select a
different job!
Only one traverse per job is allowed. Another job
must be selected.
Last traverse not yet finished or
processed! Do you want to
continue ?
The Traverse program was quit without closing a
traverse. The traverse can be continued on a new
station, left unfinished, or a new traverse started
and the old traverse data overwritten.
Do you really want to start a
new traverse ? All existing data
will be overwritten!
Confirmation of this message will start a new trav-
erse and the old traverse data will be overwritten.
Redo last station ? Measure-
ments of this station will be
overwritten!
Confirming returns to the first sight point screen for
the previous station measurements. The data from
the last station is not stored.
Exit Traverse application ?
Current station data will be
lost!!!
Quitting the program returns to the Main Menu.
The traverse can be continued later, but the current
station data will be lost.
Out of Tolerance! The tolerance limits have been exceeded. If not
accepted, the calculations can be redone.
Traverse points are re- calcu-
lated and newly stored…
An information message displayed while the adjust-
ment is calculated.