Leica FlexLine plus - 7 Programs; 7.2 Station Setup; 7.3 Surveying; 7.4 Stakeout

FlexLine plus, Table of Contents
5
7Programs
59
7.1 Common Fields 59
7.2 Station Setup 60
7.2.1 Starting 60
7.2.2 Measuring the target points 62
7.2.3 Station Setup Results 63
7.3 Surveying 65
7.4 Stakeout 66
7.5 Reference Line 69
7.5.1 Overview 69
7.5.2 Defining the Base Line 69
7.5.3 Defining the Reference Line 70
7.5.4 Measure Line & Offset 72
7.5.5 Stakeout 73
7.5.6 Grid Stakeout 75
7.5.7 Line Segmentation 77
7.6 Reference Arc 79
7.6.1 Overview 79
7.6.2 Defining the Reference Arc 79
7.6.3 Measure Line & Offset 81
7.6.4 Stakeout 82
7.7 Reference Plane 84
7.8 Tie Distance 86
7.9 Area & DTM Volume 88
7.9.1 Overview 88
7.9.2 2D / 3D Area 89
7.9.3 Area to Reference Plane 90
7.9.4 DTM Volume 91
7.9.5 Area Division 93
7.10 Remote Height 95
7.11 COGO 96
7.11.1 Starting 96
7.11.2 Inverse and Traverse 96
7.11.3 Intersections 97
7.11.4 Offsets 98
7.11.5 Line - Extension 99
7.12 Road 2D 100
7.13 Road 3D 102
7.13.1 Starting 102
7.13.2 Basic Terms 103
7.13.3 Creating or Uploading Alignment Files 107
7.13.4 Stake 108
7.13.5 Check 109
7.13.6 Stake Slope 110
7.13.7 Check Slope 113
7.14 Traverse 114
7.14.1 Overview 114
7.14.2 Starting and Configuring Traverse 115
7.14.3 Measuring Traverse 116
7.14.4 Moving ahead 118
7.14.5 Closing a Traverse 119
7.15 Tunnel 121