LevelOne IGP-1271 - Page 124

117
The switch port number.
 Event Name
Name of the Link Event which is being configured.
 Error Window
Represents the window period in the order of 1 sec for the observation of various
link events.
 Error Threshold
Represents the threshold value for the window period for the appropriate Link event
so as to notify the peer of this error.
 Error Frame Event
The Errored Frame Event counts the number of errored frames detected during the
specified period. The period is specified by a time interval ( Window in order of 1
sec). This event is generated if the errored frame count is equal to or greater than
the specified threshold for that period (Period Threshold). Errored frames are frames
that had transmission errors as detected at the Media Access Control sublayer. Error
Window for 'Error Frame Event' must be an integer value between 1-60 and its
default value is '1'. Whereas Error Threshold must be between 0-4294967295 and its
default value is '0'.
 Symbol Period Error Event
The Errored Symbol Period Event counts the number of symbol errors that occurred
during the specified period. The period is specified by the number of symbols that
can be received in a time interval on the underlying physical layer. This event is
generated if the symbol error count is equal to or greater than the specified
threshold for that period. Error Window for 'Symbol Period Error Event' must be an
integer value between 1-60 and its default value is '1'. Whereas Error Threshold
must be between 0-4294967295 and its default value is '0'.
 Seconds Summary Event
The Errored Frame Seconds Summary Event TLV counts the number of errored
frame seconds that occurred during the specified period. The period is specified by
a time interval. This event is generated if the number of errored frame seconds is
equal to or greater than the specified threshold for that period. An errored frame
second is a one second interval wherein at least one frame error was detected.
Errored frames are frames that had transmission errors as detected at the Media
Access Control sublayer. Error Window for 'Seconds Summary Event' must be an
integer value between 10-900 and its default value is '60'. Whereas Error Threshold
must be between 0-65535 and its default value is '1'.
 Buttons
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.