285
sFlow datagram. Valid range is 14 to 200 bytes with default being 128 bytes.
If the maximum datagram size does not take into account the maximum header size,
samples may be dropped.
Counter Poller Enabled
Enables/disables counter polling on this port.
Counter Poller Interval
With counter polling enabled, this specifies the interval - in seconds - between
counter poller samples.
Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
2-31 UDLD
This page allows the user to inspect the current UDLD configurations, and possibly
change them as well.
Web Interface
To configure the UDLD in the web interface:
1. Click Configuration, UDLD
2. Specify UDLD mode, Message Interval.
3. Click Apply
.
Figure 2-31: The UDLD
To Next Page
Loading...
