LevelOne IGP-1271 - 2-4.2 Snooping

30
Adding a pool and giving a name is to create a new pool with "default"
configuration. If you want to configure all settings including type, IP subnet mask
and lease time, you can click the pool name to go into the configuration page.
 Name :
Configure the pool name that accepts all printable characters, except white space. If you want
to configure the detail settings, you can click the pool name to go into the configuration
page.
 Type :
Display which type of the pool is.
Network: the pool defines a pool of IP addresses to service more than one DHCP client.
Host: the pool services for a specific DHCP client identified by client identifier or hardware
address.
If "-" is displayed, it means not defined.
 IP :
Display network number of the DHCP address pool.
If "-" is displayed, it means not defined.
 Subnet Mask :
Display subnet mask of the DHCP address pool.
If "-" is displayed, it means not defined.
 Lease Time :
Display lease time of the pool.
 Buttons
Add New Pool - Click to add a new DHCP pool.
Apply – Click to save changes.
Reset - Click to undo any changes made locally and revert to previously saved
values.
2-4.2 Snooping