496
5-5.4 Activate
The switch stores its configuration in a number of text files in CLI format. The files are
either virtual (RAM-based) or stored in flash on the switch.
The available files are:
running-config: A virtual file that represents the currently active configuration on the
switch. This file is volatile.
startup-config: The startup configuration for the switch, read at boot time. If this file
doesn't exist at boot time, the switch will start up in default configuration.
default-config: A read-only file with vendor-specific configuration. This file is read when
the system is restored to default settings.
Up to 99 other files, typically used for configuration backups or alternative
configurations.
Web Interface
To activate configuration in the web interface:
1. Chick Browser to select Maintenance/Configuration in you device.
2. Click Activate Select.
Figure 5-5.4: Configuration Activation
There are two system files:
1. default-config: A read-only file with vendor-specific configuration. This file is read
when the system is restored to default settings.
To Next Page
Loading...
