133
Port :
The switch port number of the corresponding STP CIST (and MSTI) port.
Path Cost :
Controls the path cost incurred by the port. The Auto setting will set the path cost
as appropriate by the physical link speed, using the 802.1D recommended values.
Using the Specific setting, a user-defined value can be entered. The path cost is
used when establishing the active topology of the network. Lower path cost ports
are chosen as forwarding ports in favor of higher path cost ports. Valid values are in
the range 1 to 200000000.
Priority :
Controls the port priority. This can be used to control priority of ports having
identical port cost. (See above).
Buttons
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
2-10 IPMC Profile
This page provides IPMC Profile related configurations.
2-10.1 Profile Table
The IPMC profile is used to deploy the access control on IP multicast streams. It is
allowed to create at maximum 64 Profiles with at maximum 128 corresponding rules
for each.
Web Interface
To configure the IPMC Profile Configuration in the web interface:
1. Click Configuration, IPMC Profile, Profile Table
2. Evoke to enable or disable the IPMC Profile parameter.
3. Click Apply
To Next Page
Loading...
