194
The Port column shows the list of ports for which you can configure the VLAN
Translation Mapping Group.
Default
To set the switch port to use the default VLAN Translation Group click the checkbox
and press Save.
Group ID
The VLAN Translation mappings are organized into Groups, identified by the Group
ID. This way a port is configured to use a number of VLAN Translation mappings
easily by simply configuring it to use a given group. Then number of possible
groups in a switch is equal to the number of ports present in this switch. A port can
be configured to use any of the groups, but only one at any given time. Multiple
ports can be configured to use the same group. A valid Group ID is an integer value
from 1 to 12.
Note: By default, each port is set to use the group with Group ID equal to the port
number. For example, port #1 is by default set to use group with GID = 1.
Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values
2- 19.2 VID Translation Mapping
This page displays current VLAN Translation mapping configurations. The settings can also be
configured here.
Web Interface
To configure VID Translation Mapping in the web interface:
1. Click configuration, VLAN Translation and VID Translation Mapping.
2. Specify the Group ID, VID and TVID.
3. Click Apply.
Figure 2-19.2: The VID Translation Mapping
To Next Page
Loading...
