137
and numeric characters. At least one alphabet must be present.
Start Address
The starting IPv4/IPv6 Multicast Group Address that will be used as an address
range.
End Address
The ending IPv4/IPv6 Multicast Group Address that will be used as an address
range.
Buttons
Add New Address (Range) Entry – Click to add new address range. Specify the
name and configure the addresses. Click "Save"
Apply – Click to save changes.
Reset – Click to undo any changes made locally and revert to previously saved values.
Refresh – Refreshes the displayed table starting from the input fields.
<< – Updates the table starting from the first entry in the IPMC Profile Address
Configuration.
>> – Updates the table, starting with the entry after the last entry currently displayed.
2-11MVR
The MVR feature enables multicast traffic forwarding on the Multicast VLAN. In a
multicast television application, a PC or a television with a set-top box can receive
the multicast stream. Multiple set-top boxes or PCs can be connected to one
subscriber port, which is a switch port configured as an MVR receiver port. When a
subscriber selects a channel, the set-top box or PC sends an IGMP join message to
Switch A to join the appropriate multicast. Uplink ports that send and receive
multicast data to and from the multicast VLAN are called MVR source ports.
Web Interface
To configure the MVR Configuration in the web interface:
1. Click Configuration, MVR, Configuration
2. Scroll the MVR mode to enable or disable and Scroll to set all parameters.
3. Click the save to save the setting
To Next Page
Loading...
