118
2-8 Loop Protection
The loop Protection is used to detect the presence of traffic. When switch receives
packet’s (looping detection frame) MAC address the same as oneself from port, show
Loop Protection happens. The port will be locked when it received the looping
Protection frames. If you want to resume the locked port, please find out the looping
path and take off the looping path, then select the resume the locked port and click on
“Resume” to turn on the locked ports.
Web Interface
To configure the Loop Protection parameters in the web interface:
1. Click Configuration, Loop Protection.
2. Evoke to select enable or disable the port loop Protection
3. Click the save to save the setting
4. If you want to cancel the setting then you need to click the Reset button. It will
revert to previously saved values
Figure 2-8: The Loop Protection Configuration.
To Next Page
Loading...
