LevelOne IGP-1271 - 2-25.4 Port Scheduler

240
Parameter description:
 Port
The port number for which the configuration below applies.
 Enable (E)
Enable or disable the queue policer for this switch port.
 Rate
Controls the rate for the queue policer. This value is restricted to 100-3276700 when
"Unit" is kbps, and 1-3276 when "Unit" is Mbps. The rate is internally rounded up to
the nearest value supported by the queue policer.
This field is only shown if at least one of the queue policers are enabled.
 Unit
Controls the unit of measure for the queue policer rate as kbps or Mbps.
This field is only shown if at least one of the queue policers are enabled.
 Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
2-25.4 Port Scheduler
This section provides an overview of QoS Egress Port Schedulers for all switch ports.
and the ports belong to the currently selected stack unit, as reflected by the page
header.