193
2-19 VLAN Translation
2- 19.1 Port to Group Mapping
This page allows you to configure switch Ports to use a given VLAN Translation Mapping
Group. This will enable all VLAN Translation mappings of that group (if any) on the selected
switch port.
The displayed settings are:
Web Interface
To configure Port to Group Mapping in the web interface:
1. Click configuration, VLAN Translation and Port to Group Mapping
2. Specify the Port and Group Configuration.
3. Click Apply.
Figure 2-19.1: The Port to Group Mapping
Parameter description:
Power Supply Configuration
Port:
To Next Page
Loading...
