327
sublayer. Incase of discarding, the device discards all the non-OAMPDU's.
Parser State
When in forwarding state, Device is forwarding non-OAMPDUs to higher sublayer.
When in loopback, Device is looping back non-OAMPDUs to the lower sublayer.
When in discarding state, Device is discarding non-OAMPDUs.
Organizational Unique Identification
24-bit Organizationally Unique Identifier of the vendor.
PDU Revision
It indicates the current revision of the Information TLV. The value of this field shall
start at zero and be incremented each time something in the Information TLV
changes. Upon reception of an Information TLV from a peer, an OAM client may use
this field to decide if it needs to be processed (an Information TLV that is identical
to the previous Information TLV doesn't need to be parsed as nothing in it has
changed).
PDU Permission
This field is available only for the Local DTE. It displays the current permission rules
set for the local DTE. Possible values are "Link fault","Receive only", "Information
exchange only","ANY".
Discovery State
Displays the current state of the discovery process. Possible states are Fault state,
Active state, Passive state, SEND_LOCAL_REMOTE_STATE,
SEND_LOCAL_REMOTE_OK_STATE, SEND_ANY_STATE.
Buttons
Auto-refresh: Check this box to refresh the page automatically. Automatic refresh
occurs every 3 seconds.
Refresh: Click to refresh the page.
3-4.3 Event Status
This page allows the user to inspect the current Link OAM Link Event configurations, and
change them as well.
The left pane displays the Event status for the Local OAM unit while the right pane
displays the status for the Peer for the respective port.
Web Interface
To configure the Event Status in the web interface:
To Next Page
Loading...
