326
Parameter description:
Local and Peer
Mode
The Mode in which the Link OAM is operating, Active or Passive.
Unidirectional Operation Support
This feature is not available to be configured by the user. The status of this
configuration is retrieved from the PHY.
Remote Loopback Support
If status is enabled, DTE is capable of OAM remote loopback mode.
Link Monitoring Support
If status is enabled, DTE supports interpreting Link Events.
MIB Retrieval Support
If status ie enabled DTE supports sending Variable Response OAMPDUs.
MTU Size
It represents the largest OAMPDU, in octets, supported by the DTE. This value is
compared to the remotes Maximum PDU Size and the smaller of the two is used.
Multiplexer State
When in forwarding state, the Device is forwarding non-OAMPDUs to the lower
To Next Page
Loading...
