282
2-30. sFlow
The sFlow Collector configuration for the switch can be monitored and modified here.
The configuration is divided into two parts: Configuration of the sFlow receiver (a.k.a.
sFlow collector) and configuration of per-port flow and counter samplers.
sFlow configuration is not persisted to non-volatile memory, which means that a
reboot or master change will disable sFlow sampling.
Web Interface
To configure the sFlow Agent in the web interface:
1. Click Configuration, sFlow
2. Set the parameters
3. Click the save to save the setting
4. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
.
Figure 2-30: The sFlow Configuration
To Next Page
Loading...
