LevelOne IGP-1271 - Erps

187
2-17 ERPS
The ERPS instances are configured here.
Web Interface
To configure the Ethernet Ring Protection Switching parameters in the web interface:
1. Click Configuration and ERPS.
2. Specify the Ethernet Ring Protection Switching parameters.
3. Click Apply to apply the change.
Figure 2-17: The Ethernet Ring Protection Switching
Parameter description:
Power Supply Configuration
 Delete
This box is used to mark an EPS for deletion in next save operation.
 EPS ID
The ID of the EPS. Click on the ID of an EPS to enter the configuration page. The range is
1-100.
 Domain
Port: This will create an EPS in the Port Domain. 'W/P Flow' is a Port.
 Architecture