LevelOne IGP-1271 - 2-24.2 L2 Cp

223
Fixed: The DEI value is determined by ECE rules.
 Tag Mode
The tag mode specifying whether the EVC classification must be based on the outer or
inner tag. This can be used on NNI ports connected to another service provider, where an
outer "tunnel" tag is added together with the inner tag identifying the EVC. The allowed
values are:
Inner: Enable inner tag in EVC classification.
Outer: Enable outer tag in EVC classification.
 Address Mode
The IP/MAC address mode specifying whether the EVC classification must be based on
source (SMAC/SIP) or destination (DMAC/DIP) addresses. The allowed values are:
Source: Enable SMAC/SIP matching.
Destination: Enable DMAC/DIP matching.
 Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
2-24.2 L2CP
This page displays current EVC L2CP configurations. The settings can also be
configured here.
Web Interface
To configure L2CP Port Configuration in the web interface:
1. Click configuration, Ethernet Services and L2CP.
2. Specify DMAC and L2CP Mode.
3. Click Apply.
Figure 2-24.2: The L2CP Port Configuration