LevelOne IGP-1271 - 2- 14.5 Chip Reset Schedule

181
 Failure Action :
The action when the third fail detection.
Nothing: Keep Ping the remote PD but does nothing further.
Reboot Remote PD: Cut off the power of the PoE port, make PD rebooted.
 Reboot time(sec) :
When PD has been rebooted, the PoE port restored power after the specified time.
Default: 15, range: 3-120 sec.
2- 14.5 Chip Reset Schedule
This page allows user to schedule when to reset PoE chip
Web Interface
To Display Power over Ethernet Chip Reset Schedule in the web interface:
1. Click Configuration, PoE, and Chip Reset Schedule.
2. Evoke to enable or disable the Mode.
3. Click Apply to apply the change.
Figure 2-14.5: The Chip Reset Schedule
Parameter description:
Power Supply Configuration
 Mode
Indicates the chip reset scheduling mode operation. Possible modes are:
Enabled: Enable PoE chip reset.