180
Parameter description:
Power Supply Configuration
Ping Check :
Enable Ping Check function can detects the connection between PoE port and
power device. Disable will turn off the detection.
Port :
This is the logical port number for this row.
Ping IP Address :
The PD's IP Address the system should ping.
Interval Time(sec) :
Device will send checking message to PD each interval time. Default: 30, range:
10-120 sec.
Retry Time :
When PoE port can't ping the PD, it will retry to send detection again. When the
third time, it will trigger failure action. Default: 3, range: 1-5.
Failure Log :
Failure loggings counter.
To Next Page
Loading...
