LevelOne IGP-1271 - Agent Configuration

283
Parameter description:
Agent Configuration
 IP Address
The IP address used as Agent IP address in sFlow datagrams. It serves as a unique
key that will identify this agent over extended periods of time.
Both IPv4 and IPv6 addresses are supported.
Receiver Configuration
 Owner
Basically, sFlow can be configured in two ways: Through local management using
the Web or CLI interface or through SNMP. This read-only field shows the owner of
the current sFlow configuration and assumes values as follows:
• If sFlow is currently unconfigured/unclaimed, Owner contains <none>.
• If sFlow is currently configured through Web or CLI, Owner contains <Configured
through local management>.
• If sFlow is currently configured through SNMP, Owner contains a string identifying
the sFlow receiver.
If sFlow is configured through SNMP, all controls - except for the Release-button -
are disabled to avoid inadvertent reconfiguration.
The button allows for releasing the current owner and disable sFlow sampling. The