284
button is disabled if sFlow is currently unclaimed. If configured through SNMP, the
release must be confirmed (a confirmation request will appear).
IP Address/Hostname
The IP address or hostname of the sFlow receiver. Both IPv4 and IPv6 addresses are
supported.
UDP Port
The UDP port on which the sFlow receiver listens to sFlow datagrams. If set to 0
(zero), the default port (6343) is used.
Timeout
The number of seconds remaining before sampling stops and the current sFlow
owner is released. While active, the current time left can be updated with a click on
the Refresh-button. If locally managed, the timeout can be changed on the fly
without affecting any other settings.
Max. Datagram Size
The maximum number of data bytes that can be sent in a single sample datagram.
This should be set to a value that avoids fragmentation of the sFlow datagrams.
Valid range is 200 to 1468 bytes with default being 1400 bytes.
Port Configuration
Port
The port number for which the configuration below applies.
Flow Sampler Enabled
Enables/disables flow sampling on this port.
Flow Sampler Sampling Rate
The statistical sampling rate for packet sampling. Set to N to sample on average
1/Nth of the packets transmitted/received on the port.
Not all sampling rates are achievable. If an unsupported sampling rate is requested,
the switch will automatically adjust it to the closest achievable. This will be reported
back in this field.
Flow Sampler Max. Header
The maximum number of bytes that should be copied from a sampled packet to the
To Next Page
Loading...
