488
5-4.2 Firmware Selection
This page provides information about the active and alternate (backup) firmware
images in the device, and allows you to revert to the alternate image.
The web page displays two tables with information about the active and alternate
firmware images.
Note:
1. In case the active firmware image is the alternate image, only the "Active
Image" table is shown. In this case, the Activate Alternate Image button is
also disabled.
2. If the alternate image is active (due to a corruption of the primary image
or by manual intervention), uploading a new firmware image to the device
will automatically use the primary image slot and activate this.
3. The firmware version and date information may be empty for older
firmware releases. This does not constitute an error.
Web Interface
To configure a Firmware Upgrade Configuration in the web interface:
1. Chick Browser to select Maintenance/Software in you device.
2. Click Image Select.
Figure 5-4.2 The Firmware selection
To Next Page
Loading...
