LevelOne IGP-1271 - 2- 14.2 Power Delay

176
2- 14.2 Power Delay
This page allows the user to setting the delay time of power providing after device
rebooted.
Web Interface
To Display Power over Ethernet Status in the web interface:
1. Click Configuration, PoE, and Power delay.
2. Enable the port to the power device.
3. Specify the power providing delay time when reboot.
4. Click Apply to apply the change.
Figure 2-14.2: The PoE Power Delay
Parameter description:
Power Supply Configuration
 Port :
This is the logical port number for this row.
 Delay Mode :