LevelOne IGP-1271 - 2- 14.4 Auto Checking

179
Power Supply Configuration
 Port :
This is the logical port number for this row.
 Status :
PoE Scheduling Status.
Enabled: Enable POE Scheduling.
Disabled: Disable POE Scheduling.
 Hour :
The time of PoE port provide power of a day.
2- 14.4 Auto Checking
This page allows the user to specify the auto detection parameters to check the linking
status between PoE ports and PDs. When it detected the fail connect, will reboot
remote PD automatically.
Web Interface
To Display Power over Ethernet Auto Checking in the web interface:
1. Click Configuration, PoE, and Auto checking.
2. Enable the Ping Check function.
3. Specify the PD’s IP address, checking interval, retry time, failure action and reboot
time.
4. Click Apply to apply the change.
Figure 2-14.4: The PoE Scheduling