140
membership reports on source ports. In Compatible mode, MVR membership
reports are forbidden on source ports. The default is Dynamic mode.
Tagging
Specify whether the traversed IGMP/MLD control frames will be sent as Untagged
or Tagged with MVR VID. The default is tagged.
Priority
Specify how the traversed IGMP/MLD control frames will be sent in prioritized
manner. The default Priority is 0.
LLQI
Define the maximum time to wait for IGMP/MLD report memberships on a receiver
port before removing the port from multicast group membership. The value is in
units of tenths of a seconds. The range is from 0 to 31744. The default LLQI is 5
tenths or one-half second.
Interface Channel Setting
When the MVR VLAN is created, click the Edit symbol to expand the corresponding
multicast channel settings for the specific MVR VLAN. Summary about the Interface
Channel Setting (of the MVR VLAN) will be shown besides the Edit symbol.
Port
The logical port for the settings.
Port Role
Configure an MVR port of the designated MVR VLAN as one of the following roles.
Inactive: The designated port does not participate MVR operations.
Source: Configure uplink ports that receive and send multicast data as source ports.
Subscribers cannot be directly connected to source ports.
Receiver: Configure a port as a receiver port if it is a subscriber port and should
only receive multicast data. It does not receive data unless it becomes a member of
the multicast group by issuing IGMP/MLD messages.
Be Caution: MVR source ports are not recommended to be overlapped with
management VLAN ports. Select the port role by clicking the Role symbol to switch
the setting. I indicates Inactive; S indicates Source; R indicates Receiver. The default
To Next Page
Loading...
