LevelOne IGP-1271 - Page 190

183
Power Supply Configuration
 Delete
This box is used to mark an EPS for deletion in next save operation.
 EPS ID
The ID of the EPS. Click on the ID of an EPS to enter the configuration page. The range is
1-100.
 Domain
Port: This will create an EPS in the Port Domain. 'W/P Flow' is a Port.
 Architecture
Port: This will create a 1+1 EPS.
Port: This will create a 1:1 EPS.
 W Flow
The working flow for the EPS - See 'Domain'.
 P Flow
The protecting flow for the EPS - See 'Domain'.
 W SF MEP
The working Signal Fail reporting MEP.
 P SF MEP
The protecting Signal Fail reporting MEP.
 APS MEP
The APS PDU handling MEP.
 Alarm
There is an active alarm on the EPS.
 Buttons:
Apply – Click to save changes.