191
MAC-Based Authentication under 802.1X. Each port can do learning based upon the
following settings:
Auto :
Learning is done automatically as soon as a frame with unknown SMAC is received.
Disable :
No learning is done.
Secure :
Only static MAC entries are learned, all other frames are dropped.
NOTE: Make sure that the link used for managing the switch is
added to the Static Mac Table before changing to secure
learning mode, otherwise the management link is lost and can
only be restored by using another non-secure port or by
connecting to the switch via the serial interface.
Static MAC Table Configuration
The static entries in the MAC table are shown in this table. The static MAC table can
contain 64 entries. The maximum of 64 entries is for the whole stack, and not per
switch.
The MAC table is sorted first by VLAN ID and then by MAC address.
Delete :
Check to delete the entry. It will be deleted during the next save.
VLAN ID :
The VLAN ID of the entry.
MAC Address :
The MAC address of the entry.
Port Members :
Checkmarks indicate which ports are members of the entry. Check or uncheck as
needed to modify the entry.
To Next Page
Loading...
