233
IPv4: The ECE will match IPv4 frames only.
IPv6: The ECE will match IPv6 frames only.
Actions
Direction
The EVCs and ECEs are used to setup flows in one or both directions as determined
by the ECE Direction parameter. If the ECE is bidirectional, the ingress rules of the
NNI ports will be setup to match the traffic being forwarded to NNI ports. Possible
values are:
Both: Bidirectional.
UNI-to-NNI: Unidirectional from UNI to NNI.
NNI-to-UNI: Unidirectional from NNI to UNI.
EVC ID
The EVC ID for the ECE. The ECE is only active when mapping to an existing EVC.
Possible values are:
Specific: The range is from 1 through 256.
None: The ECE does not map to an EVC.
Tag Pop Count
The ingress tag pop count for the ECE. The possible range is from 0 through 2.
Policy ID
The ACL Policy ID for the ECE. The range is from 0 through 255.
Class
The traffic class for the ECE. The range is from 0through 7.
Egress Outer Tag
Outer Tag Mode
The outer tag for nni-to-uni direction for the ECE. The possible values are:
Enable: Enable outer tag for nni-to-uni direction for the ECE.
Disable: Disable outer tag for nni-to-uni direction for the ECE.
Outer Tag PCP/DEI Preservation
The outer tag PCP and DEI preservation for the ECE. The possible values are:
To Next Page
Loading...
