251
The Port coulmn shows the list of ports for which you can configure dscp ingress
and egress settings.
Ingress :
In Ingress settings you can change ingress translation and classification settings for
individual ports.
There are two configuration parameters available in Ingress:
3. Translate : To Enable the Ingress Translation click the checkbox
4. Classify: Classification for a port have 4 different values
Disable: No Ingress DSCP Classification.
DSCP=0: Classify if incoming (or translated if enabled) DSCP is 0.
Selected: Classify only selected DSCP for which classification is enabled as
specified in DSCP Translation window for the specific DSCP.
All: Classify all DSCP.
Egress :
Port Egress Rewriting can be one of below parameters
Disable: No Egress rewrite.
Enable: Rewrite enable without remapped.
Remap: DSCP from analyzer is remapped and frame is remarked with
remapped DSCP value.
Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
Auto-refresh :
To evoke the auto-refresh icon then the device will refresh the information
automatically.
To Next Page
Loading...
