280
Enable GVRP globally
The GVRP feature is enabled by setting the check mark in the checkbox named
Enable GVRP.
GVRP protocol timers
Join-time is a value in the range 1-20 in the units of centi seconds, i.e. in units of one
hundredth of a second. The default is 20.
Leave-time is a value in the range 60-300 in the units of centi seconds, i.e. in units of
one hundredth of a second. The default is 60.
Leave All-time is a value in the range 1000-5000 in the units of centi seconds, i.e. in
units of one hundredth of a second. The default is 1000.
Max number of VLANs
When GVRP is enabled a maximum number of VLANs supported by GVRP is specified.
By default this number is 20. This number can only be changed when GVRP is turned off.
To Next Page
Loading...
