370
This section contains information about the state of the server and the latest
round-trip time.
IP address and UDP port for the authentication server in
question.
Shows the state of the server. It takes one of the following
values:
Disabled: The selected server is disabled.
Not Ready: The server is enabled, but IP communication is
not yet up and running.
Ready: The server is enabled, IP communication is up and
running, and the RADIUS module is ready to accept access
attempts.
Dead (X seconds left): Access attempts were made to this
server, but it did not reply within the configured timeout. The
server has temporarily been disabled, but will get re-enabled
when the dead-time expires. The number of seconds left
before this occurs is displayed in parentheses. This state is
only reachable when more than one server is enabled.
radiusAuthClientExtRoundTr
ipTime
The time interval (measured in milliseconds) between the
most recent Access-Reply/Access-Challenge and the
Access-Request that matched it from the RADIUS
authentication server. The granularity of this measurement is
100 ms. A value of 0 ms indicates that there hasn't been
round-trip communication with the server yet.
RADIUS Accounting Statistics
The statistics map closely to those specified in RFC4670 - RADIUS Accounting Client MIB.
Use the server select box to switch between the backend servers to show details for.
Packet Counters
RADIUS accounting server packet counter. There are five receive and four transmit counters.
radiusAccClientExtResponses
The number of RADIUS packets (valid
or invalid) received from the server.
To Next Page
Loading...
