LevelOne IGP-1271 - 5-4.2 Firmware Selection

481
8 202-39-253-11.HINET-IP.hinet.net. (202.39.253.11) 10 ms 10 ms
You can configure the following properties:
 Protocol
The protocol(ICMP, UDP, TCP) packets to send.
 IP Address
The destination IP Address.
 Wait Time
Set the time (in seconds) to wait for a response to a probe (default 5.0 sec). Values
range from 1 to 60. The payload size of the ICMP packet. Values range from 2bytes
to 1452 bytes.
 Max TTL
Specifies the maximum number of hops (max time-to-live value) traceroute will
probe. Values range from 1 to 255. The default is 30.
 Probe Count
Sets the number of probe packets per hop. Values range from 1 to 10. The default is
3.
 Buttons
Start: Click to start transmitting ICMP packets.
New Ping: Click to re-start diagnostics with PING.