LSIS SV-IS7 - Navigating Modes; Mode Navigation at the Factory Default

Using the Keypad
90
5.3 Navigating Modes
5.3.1 Mode Navigation at the Factory Default
You can change the display to navigate modes by using the [MODE] key. The User & Macro
Mode and Trip Mode are not displayed when the inverter is set to the factory default settings.
• Displays when the inverter is powered on. This is the
display of Monitor mode (MON).
• Press the [MODE] key.
• You are now in Parameter mode (PAR).
• Press the [MODE] key.