1.1.2
Checking the Product for Defects or Damage
If you suspect that the product has been mishandled or damaged in any way, contact the LSIS
Customer Support center with the phone numbers listed on the back cover of this manual.
1.1.3
Preparing the Product for Installation and Operation
Preparation steps for installation and operation may slightly vary by product type and
application. Refer to the manual and prepare the product accordingly.
1.1.4
Installing the Product
Refer to the installation section of this manual and install the product correctly considering the
installation and operating conditions at the installation location, such as installation clearances,
to prevent premature deterioration or performance loss.
1.1.5
Connecting the Cables
Connect the power input/output and signal cables to the terminal block according to the
instructions provided in this manual. Ensure that all the cables are connected correctly before
supplying power to the product. Incorrect cable connections may damage the product.
To Next Page
Loading...
Need help?
General