5.8.2
Multiple Faults at a Time during Inverter Operation
• If multiple fault trips occur at the same time, the
number of fault trips that occurred is displayed next
to the fault trip type.
• Press the [PROG/ENT] key.
• The types of all the fault trips are displayed.
• Press the [PROG/ENT] key.
• The display mode that was shown before you
checked the fault information is displayed.
5.8.3
Saving and Monitoring the Fault Trip History
Previous fault trips can be saved in Trip mode. You can save up to 5 previous fault trips. Fault
trips caused by resetting the inverter, as well as low voltage faults caused by the inverter being
switched off, are also saved.
If there are more than 5 fault trips, the oldest 5 fault trips are automatically deleted.
To Next Page
Loading...
Need help?
General