• If a fault trip occurs during inverter operation, the
inverter enters Trip mode and displays the type of
fault trip that has occurred.
• If you press the [STOP/RESET] key or an input is
entered on the terminal, the fault trip is
automatically saved and the display status that was
displayed before the fault trip occurred is displayed.
• Press the [MODE] key to move to Trip mode.
• The most recent fault trip is saved in the Last-1 code.
• Press the [Right] key.
• The previous fault trips are saved in the Last-2 code.
• If another fault trip occurs, the previous fault trips
saved in the Last-2 code move to the Last-3 code.
To Next Page
Loading...
Need help?
General