LSIS SV-IS7 - Parameter Settings in Other Modes and Groups

Using the Keypad
101
Using the
Keypad
5.6.2 Parameter Settings in Other Modes and Groups
The following example demonstrates how to change the frequency of the Drive (DRV) group in
Parameter mode. The frequency in the other modes or groups can be set as follows.
• This is the initial display in Parameter mode.
• Press the [Down] key.
• You have moved to the 01 frequency setting code.
• Press the [PROG/ENT] key.
• The cursor flashes and you can enter the desired
frequency.
• If the frequency reference is set to 10 Hz, press the
[Left] or [Right] keys to move the cursor to the
desired place.
• Press the [Up] key to enter 10 Hz and then press the
[PROG/ENT] key.
• The frequency reference is set to 10 Hz.