LSIS SV-IS7 - 5.8 Monitoring Faults

Using the Keypad
94
• You are now in Parameter mode (PAR).
• The Drive Group (DRV) of Parameter mode is
displayed.
• Press the [Right] key.
• You are now in the Basic Function Group (BAS).
• Press the [Right] key.
• You are now in the Advanced Function Group (ADV).
• Press the [Right] key 7 times.
• The group sequence will change and the Protection
Function Group (PRT) will be displayed.
• Press the [Right] key.
• You are now in the Drive group (DRV) of the
Parameter group again.