MAINTENANCE
Page 129
Oil Level Check
When checking oil levels, the vehicle must be
parked on level ground and the units at normal
operating temperature. Components must be
filled to the correct level. DO NOT OVERFILL.
The left-side dipstick location shown in
Figure 107 applies to most ASET™ engines.
Early production AI/AMI engines and AI engines
built with the traditional front water pump
configuration still utilize the right-side dipstick
location.
107
Figure 107 — Dipstick, Left-Side Installation (Most
ASET™ Engine Applications)
For accurate oil level readings, the dipstick must
be inserted into the dipstick tube with the “L” and
“F” markings facing upward. On conventional
cabs, this will be with the finger-loop facing
outboard, or away from the engine. On LE and
MR models, the “F” and “L” marks must be facing
up as the dipstick is inserted into the dipstick
tube.
108
Figure 108 — Oil Level Check
1. Filter Mounting Bracket
2. Isolator
3. Dipstick Tube
4. Oil Pan
5-111.bk Page 129 Monday, July 10, 2006 2:26 PM
To Next Page
Loading...
