Page 64
DESCRIPTION AND OPERATION
High-Pressure Fuel Injection Lines
The high-pressure fuel lines for each cylinder
(Figure 72) are short (17 inches) and have the
strength to withstand the high fuel pressure
generated by the electronic unit pumps. A
standard configuration with the same part number
is used for all
cylinders and all engine models.
Also, there are no clamps used on these lines.
72
Figure 72 — Fuel Injection Lines
Fuel Injector Assemblies
Injector nozzles used with the ASET™ engines
are 22 mm in diameter with the material strength
to match the high operating pressures of the
electronic unit pumps. The nozzle holder is also
fitted with a locating pin to ensure proper
alignment of the injector assembly in the cylinder
head. The locating pin is on the same side as the
nozzle holder fuel inlet port. Refer to Figure 73.
73
Figure 73 — Fuel Injector Nozzle Holder
5-111.bk Page 64 Monday, July 10, 2006 2:26 PM
To Next Page
Loading...
