REPAIR INSTRUCTIONS, PART 1
Page 155
EGR Mixer Tube Removal
[214 HL]
1. Disconnect the electrical leads to the
CMCAC outlet pressure and temperature
sensors.
2. Remove the capscrew from the support
bracket at the side of the EGR gas mixer
tube. The bracket is attached between the
mixer tube and the coolant manifold
(Figure 140).
140
Figure 140 — Support Bracket
3. Remove the capscrews attaching the mixer
tube to the inlet manifold (Figure 141) and
remove the tube.
141
Figure 141 — EGR Gas Mixer Tube, Installed
1. Mixer Tube
2. Cool Tube Port
3. Support Bracket
4. Coolant Manifold
1. CMCAC Pressure
Sensor
2. CMCAC Temperature
Sensor
3. Pressure Release Valve
4. EGR Cool Tube
5. Mixer Tube
6. Capscrews
7. Boost Pressure Relief
Outlet Tube Clamp
8. Mixer Tube Capscrews
5-111.bk Page 155 Monday, July 10, 2006 2:26 PM
To Next Page
Loading...
